Once you accept the connection, you should land on the remote system desktop. On Fedora 30/29/CentOS 7, you should accept the session request for you to access the remote desktop. To connect to Fedora 30/29/CentOS 7 desktop using AnyDesk, just launch the AnyDesk on your system and use the 6 digit address for the remote AnyDesk.Īs you connect, you should see a connection screen Once the installation of AnyDesk is done, then you are ready to use it. Jun 11 22:27:47 localhost.localdomain systemd: Started AnyDesk. Loaded: loaded (/etc/systemd/system/rvice enabled vendor preset: disabled)Īctive: active (running) since Tue 22:27:47 EAT 2min 53s ago You can check the status by executing the command below systemctl status rvice Once the installation is done, AnyDesk will run by default.

Package Architecture Version Repository Size You can as well install AnyDesk directly once you get the URL as shown below yum install Last metadata expiration check: 0:13:50 ago on Tue 10:13:08 PM EAT.Īnydesk_5.1.0-1_amd64.rpm 1.4 MB/s | 4.3 MB 00:02 sudo yum localinstall anydesk_5.1.0-1_amd64.rpm Once the download is done, run the command below to instal AnyDesk. You can simply use wget to get the binary. To install AnyDesk on Fedora 30/29/CentOS 7, navigate to the Linux AnyDesk installer downloads page and download the RPM binary package for Fedora 30/29/CentOS 7. dnf updateĭnf upgrade Download AnyDesk Binary Installer

Terminal install anydesk centos 7